DeWalt DWE1622 Instruction Manual page 7

Fig. C
Lubrication System (Fig. A, D)
Filling the Coolant Bottle

WARNING: Do not pour cutting fluid into the
bottle while mounted in the bracket. Do not
allow cutting fluid to enter the drill motor. Electric
shock may result.
nOTE: The lubrication system is designed for dispensing
cutting fluids specifically intended for drilling. Other liquids
may damage the system.
1. Turn the the flow regulator
close.
2. Remove coolant bottle
10
3. Unscrew the cap .
21
4. Fill the container with cutting coolant diluted
with water.
5. Screw the cap back on.
6. Place coolant bottle into magnetic bracket
Fig. D
12
23
11
Fitting the Lubrication System
(Fig. A, D)

WARNING: Do not use the lubrication system in
vertical surfaces or overhead drilling applications.
Only use the lubrication system for horizontal drilling
applications, as shown in Figure A.
19 16
19
20
13 counterclockwise to
from magnetic bracket .
5
5 .
22
21
10
5
11
13
1. Place coolant bottle 10 into the magnetic bracket
then slide the magnetic bracket onto the either side of
the steel strip 22 .
2. Attach the coolant tube 11
a. Remove the nut 23 and thread it onto the tube
b. Slide the tube onto the nipple and tighten the
nut .
23
3. Attach the tube to the coupling connector
the gearbox.
a. Remove the nut from the connector, then pass the
coolant tube 11 through the nut
b. Slide the coolant tube
then tighten the nut.
c. To remove, loosen the nut
from the connector.
In order to use the lubrication system, the coolant bottle
must be filled with a sufficient amount of cutting fluid.
Lubrication in horizontal applications
(Fig. D)
1. Adjust the fluid flow as required using the flow
regulator 13 .
2. Add more cutting fluid if the shavings become blue.
Lubrication in Vertical and overhead
applications
Dip the cutter in cutting paste or apply an appropriate spray.
Fitting the Safety Chain (Fig. E)

WARNING: Always use the safety chain.
Feed the provided safety chain
unit and around the workpiece and secure in place.
Fig. E
9
Inserting and Removing an Accessory
(Fig. F, G)
The tool holder accepts annular cutters with a 3/4" shank
with two flats.

CAUTION: Laceration hazard. The cutter teeth
are sharp.
1. Slide the pilot pin 26 through the hole in the center of
the cutter shank.
2. Push up on the quick-release collar
English
5 ,
to the coolant bottle:
11
12 on
23 .
11 onto the nipple to install,
, then pull the tube
23
10
9 through the handle of
15
.
24
.
5