Dometic CoolAir RTX2000 Operating Manual page 14

Using the parking cooler
• Select a suitable temperature and operating mode.
• Make sure the blower nozzles (fig. 1 1, page 3) and intake grille (fig. 1 2,
page 3) are not covered by cloths, paper or other objects.
• The best cooling capacity is achieved when the blower nozzles (fig. 1 1,
page 3) are not directed towards the intake grille (fig. 1 2, page 3).
Always observe the following
• If you would like the parking cooler to match the colour of your vehicle, only paint
the upper shell casing of the parking cooler.
Only paint this when it has been removed. Use light colours when possible.
• Wash your vehicle regularly, as dirty driver's cabs heat up more quickly.
• Make sure that the performance of the parking cooler is not affected by other
sources of heat (e.g. waste heat from cold machines).
7.2 Switching on the parking cooler
A
NOTICE!
Never close all of the air nozzles of the parking cooler simultaneously.
The system would ice up inside.
I
NOTE
The first time the parking cooler is used, there may be a slight smell. This
odour is caused by a design feature and ends after the system has been
running for a short time.
➤ With the system switched off, press the
✓ The fan starts.
✓ The Power LED (fig. 2 7, page 4) lights up.
✓ The digital display (fig. 2 1, page 4) shows the current status of the parking
cooler (see chapter "Display" on page 12).
I
NOTE
Depending on the system status, the system compressor is switched on
with a delay of up to 180 seconds.
14
RTX2000, SPX1200IC
button.
EN