Brake Pad Replacement; Front Pad Removal; Front Pad Installation - Buell XB9S 2003 Manual

HOME

BRAKE PAD REPLACEMENT

Front Pad Removal

1. See Figure 1-15. Loosen pin hanger (2) but do not
remove.
2. Rotate wheels so that caliper is centered between rotor
mounting fasteners (1).
3. Remove lower caliper mounting fastener (4) that secures
caliper to fork lower.
4. Loosen but do not remove upper caliper mounting fas-
tener (3) that secures caliper to fork lower.
5. Remove pin hanger (2).
6. Rotate caliper counterclockwise to allow access to outer
pad.
7. Remove outer pad from right side.
8. Remove inner pad from left side by pulling rearward,
rotating pad 90 degrees and pulling through wheel open-
ing.

Front Pad Installation

1. Push pistons in with suitable tool such as a clean paint
scraper until fully seated in bores. Be careful not to dam-
age rotor.
2. Install new inner pad from left side of motorcycle.
3. Install new outer pad from right side of motorcycle.
4. See Figure 1-15. Install pin (2) making sure it engages
hole on both pads and spring clip.
5. Rotate caliper clockwise to align mounting fastener hole.
6. See Figure 1-15. Install lower caliper mounting
fastener (4).
7. Tighten both caliper mounting fasteners (3 & 4) to 35-
37 ft-lbs (48-50 Nm).
8. Tighten pin (2) to 11-15 ft-lbs (15-20 Nm).
NOTE
Avoid making hard stops for the first 100 miles (160 km) to
allow new brake pads to "wear in" properly with the rotor.
1-20 2003 Buell XB9S: Maintenance
8346
1
1. Rotor mounting fastener (6)
2. Front caliper pin hanger
3. Upper caliper mounting fastener
4. Lower caliper mounting fastener
Figure 1-15. Front Brake Caliper
3
2
4