Installation - Zanussi ZWF71463W User Manual

Maximum Load
Spin Speed
Spin drying performance
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
2) At the end of spinning phase.

INSTALLATION

WARNING! Refer to Safety chapters.
UNPACKING
1. Open the door. Remove all the items from the
drum.
Accessories delivered with the
appliance may vary depending on
the model.
2. Put the packaging element on the floor behind
the appliance and carefully put it down onto its
rear side. Remove the polystyrene protection
from the bottom.
CAUTION! Do not lay washing
machine on its front.
3. Put the appliance back into an upright position.
Remove the power supply cable and the drain
6
Cotton
Maximum spin speed
Remaining moisture
1
2
7 kg
1400 rpm
2)
48 %
hose from the hose holders.
WARNING! It is possible to see
water flowing from the drain hose.
This is because the washing
machine has been tested at the
factory.
4. Remove the three transit bolts and pull out the
plastic spacers.
5. Put the plastic caps, that you find in the user
manual bag, in the holes.