Electrical Connection - Zanussi ZWF71463W User Manual

4. To a stand pipe with vent hole - Insert the drain
hose directly into a drain pipe. Refer to the
illustration.
The end of the drain hose must always
be ventilated , i.e. the inner diameter of
the drain pipe (min. 38 mm - min. 1.5")
must be larger than the external
diameter of the drain hose.
5. Without the plastic hose guide, to a sink spigot-
Put the drain hose in the spigot and tighten it with a
clamp. Refer to the illustration.
Make sure that the drain hose makes a loop to
prevent particles going into the appliance from the
sink.
8
1
ø16
2
W011
Connect the drain hose to the spigot and tighten it
with a clamp. Make sure that the drain hose makes
a loop to prevent particles going into the appliance
from the sink.
6. Position the hose directly to a built-in drain pipe
in the room wall and tighten it with a clamp.

ELECTRICAL CONNECTION

At the end of installation you can connect the mains
plug to the mains socket.
The rating plate on the inner edge of the appliance
door and the 'Technical Data' chapter indicate the
necessary electrical ratings. Make sure that they are
compatible with the mains power supply.
Check that your domestic electrical installation can
take the maximum load required, also taking into
account any other appliances in use.
Connect the appliance to an earthed socket.
The power supply cable must be easily accessible
after installing the appliance.
For any electrical work required to install this
appliance, contact our Authorised Service Centre.
The manufacturer does not accept any
responsibility for damage or injury through failure to
comply with the above safety precaution.