tams elektronik LC Series Manual page 15

LC modules
In the program "moving vehicle": The front and back lights are always
switched on. It is possible to connect a loudspeaker as a horn (not
included) to output 3, the volume can be reduced by connecting a series
resistor (approx. 10 to1 k). The flashing lights on the left and the
right, the horn and the stop lights are switched on and off at random.
After the stop lights having been lighted the flasher is switched on,
afterwards the stop lights and a little bit later the flasher are switched off.
In the program "standing vehicle": The front and back lights are
switched on most of the time. Now and again the flashing lights on the
left and the right, the warning flasher and the interior light are switched
on. After the interior light having been lighted the front and back lights
and then the interior light are switched off. Afterwards all lights are
switched off for a period.
LC-19 "Paparazzi flash": The photographer´s flash lights are
connected to the five outputs of the module. They flash at random
independently from each other. At irregular intervals flashlight
thunderstorms break when all flashlights are used nearly simultaneously
and several times close together. Using white LEDs creates a very
realistic effect. The input JP2 has no function in this version.
LC-20 "Roadworks vehicle": The module´s five outputs control the
lighting of a complete roadworks vehicle including a trailer. Assignment
of the outputs:
1: Lane indication arrow of the trailer
(gets slowly brighter and then darker)
2: Flash lights of the trailer
3 and 4: Warning flasher of the service vehicle
5: Double flash light
The input JP2 has no function in this version.
English
Page 15