Control Buttons - Decatur Electronics Genesis II Select User Manual & Installation Manual

4.1 Control Buttons

POWER (PWR): powers the Genesis II Select™ on and off.
OPTION (OPTN): The City/Highway option helps reduce shadowing
by setting a different minimum patrol speed for city and highway
speed conditions. This option works only while the unit is set in a
Moving Mode and the motor vehicle is not equipped with a VIP.
STOPWATCH MODE [OPT]: To place the Genesis II Select™ into the
Stopwatch operational mode, press and hold the OPTN button for
two seconds. The letters StpW will appear in the MODE window. Press
the OPTN button again to exit this mode. See Section 6.9 for a full
description of the Stopwatch Mode.
PATROL SPEED LOCK, RECALL and BLANKING [OPT]: This feature
comes standard with the Genesis II Select™ and will enable the patrol
officer to lock a target speed which will then become displayed in
the locked window, while remembering internally what the patrol
speed was at the time the speed was locked. The Genesis II Select™
will, as long as the antenna remains activated, continue to track both
the speed of the target in the target window and the patrol motor
vehicle speed in the patrol window .
1. To blank the patrol speed, press the OPTN button. Then press the
OPTN button again to recall it.
2. To permanently remove the locked patrol speed, reactivate the
antenna by turning it on.
TEST (TEST): Pressing the TEST button starts an extensive self test of
the radar unit's circuitry. During self test, the system will not power
down until the test is complete. If the self test fails, the SYS message
will appear in the MODE window. For more information on tests, see
Section 8: Field Tests.
Pressing and holding the test button activates the menu feature.
This feature allows the operator to adjust some of the settings of the
radar. See MENU FEATURE.
28
16/September/2015