Offices To Go OTGHABASE2 Assembly Instructions Manual page 4

STEP 3 - Assemble legs and
crossrail
• Connect cross rails to legs,
leave screws from Step 1
loose.
STEP 4 - Connect Hex Rods
• Insert hex rod into motor
(Item 12) and slide tube over
the hex rod in left leg (Item 2).
• Slide mechanism to desired
size.
• NOTE: Table top should
overhang base on the left
and right side by a minimum
of 1" and a maximum of
2.25".
• Tighten knobs on the tube
(Item 4).
Open Close
Ouvrir Fermer
4/6
www.officestogo.com
HEIGHT ADJUSTABLE TABLES
ASSEMBLY INSTRUCTIONS
revised 010720