Step 1: Assemble Back Legs - modway EEI–2941 Quick Start Manual

EEI–2941
ARM CHAIR
STEP 1:
Put Chair Body (1) upside down on a carpeted or padded surface.
Open Velcro on the bottom of Chair Body (1) and find the package of Front Legs (2), Back Legs (3) and Hardware as shown.
Velcro
STEP 2:
Make the position for assembling Front Legs (2) and Back Legs (3) fully visible.
Place 2 pieces of Back Legs (3) to the back position of Chair Body (1) as shown.
Insert 2 pieces of Short Bolt (A) with 2 pieces of Flat Washer (C) into the bottom pre-drilled holes on Back Legs (3)
through the bottom pre-drilled on the back of Chair Body (1).
Insert 2 pieces of Long Bolt (B) with 2 pieces of Flat Washer (C) into the top pre-drilled holes on Back Legs (3) through
the top pre-drilled on the back of Chair Body (1).
Use Allen Wrench (D) to tighten Short Bolts (A) and Long Bolts (B). Do not fully tighten the Bolts (A&B) at this step.
A A
A
C
B
C
3
1
Ax2 Bx2
Customer Service 908-368-1025︱www.modwayfurniture.com
D
B
C
3
C
Cx4
Package of Front Legs, Back Legs and Hardware
D
B
A
C
C
Dx1
3
1
Hardware & Tools required
Page 2 of 4