Advertisement
45 You may have to press it 2 or 3 times to pump water through the system.
46 Leave 4 seconds between shots, to let the steam build up.
C AFTER USE
47 Set the temperature control to •. Set the steam control to S.
48 Unplug the appliance.
49 Press the V button, and keep it pressed in. This opens the valve
50 Hold it over a sink, turn it upside down, and drain the water from the
reservoir, via the water inlet.
51 Release the V button. This closes the valve.
52 Sit the iron on its heel.
53 Leave it to cool down completely.
54 When it's cold, wipe off any moisture, and wind the cable round the heel.
55 Press the clip over the cable, to keep it tight and tidy.
56 Clean the outside surfaces of the appliance with a damp cloth.
57 Remove spots from the soleplate with a little vinegar.
58 Store the iron on its heel, to avoid corrosion and damage to the soleplate.
C S ELF CLEAN
59 To prevent scale building up, use the self clean function at least monthly in normal
water areas, more often in hard water areas.
, Products returned under guarantee with faults due to scale will be subject to a
repair charge.
60 You'll need a basin or a large bowl to catch the water coming out of the soleplate.
61 Fill the reservoir to the max mark.
62 Set the temperature control to max. Set the steam control to S.
63 Sit the iron on its heel.
64 Put the plug into the power socket.
65 Wait till the light goes off.
66 Hold the iron over the basin or bowl, with the soleplate down.
67 Press the C button, and keep it pressed in.
68 Gently move the iron to and fro.
69 Water and steam will wash scale and dust through the soleplate.
, Keep clear of the escaping water and steam.
70 Carry on till the reservoir is empty.
71 Release the C button.
, Jump to point 47.
5
V
C
Advertisement
