Related Commands - H3C MSR Series Troubleshooting Manual

PPP State Change:
*Oct 22 14:00:07:013 2014 3640 RADIUS/7/PACKET:
User-Name="\r0W'ZK5A9fd00001"
User-Password=******
Service-Type=Framed-User
NAS-Identifier="3640"
NAS-Port=4096
NAS-Port-Type=Ethernet
Calling-Station-Id="8c21-0a7e-71c5"
Acct-Session-Id="00000005201410221400070000001e001
NAS-Port-Id="slot=65535;subslot=0;port=0;vlanid=0"
H3c-Ip-Host-Addr="255.255.255.255 8c:21:0a:7e:71:c5"
NAS-IP-Address=60.191.123.92
H3c-Product-Id="H3C MSR36-40"
H3c-Nas-Startup-Timestamp=1413972953
....
*Oct 22 13:59:46:225 2014 3640 PPP/7/PAP_EVENT_0:
PPP Event:
*Oct 22 13:59:46:225 2014 3640 PPP/7/AUTH_ERROR_0:
PPP Error:
As the debugging information shows, the username received by PPP is incorrect. The MSR
router has no problems.
Troubleshoot the dialup mode of the small home router.
2.
A small home router typically uses the automatic dialup method. At first, the router uses the
normal dialup mode. If the dialup fails, the router will try various special dialup modes. Typical
authentication servers do not support special dialup modes. As a result, a large number of
authentication failures occur. When such problems occur, you need to troubleshoot the failure
reason for the first dialup failure.
TIP:
You do not need to be concerned about the abnormal usernames caused by special dialup modes
on the small home router.

Related commands

This section lists the commands that you might use for troubleshooting PPPoE.
Command
display pppoe-server session summary
debugging ppp
debugging ppp
debugging ppp
debugging radius packet
Virtual-Access0 PAP: ServerListen --> WaitAAA
Virtual-Access0 PAP Receive AAA Result Event
State WaitAAA
Virtual-Access0 PAP: Receive AAA reject message, authentication failed!
lcp all
pap all
ipcp all
Description
Displays PPPoE session information.
Enables debugging for the PPP LCP phase.
Enables debugging for the PPP PAP phase.
Enables debugging for the PPP IPCP phase.
Enables debugging for the RADIUS packets.
26
225"