BW Technologies GasAlert Micro 5 Quick Setup Manual

BW Technologies GasAlert Micro 5 Personal Multigas Detector
Sensor Settings
1. With the meter turned on, press and hold both the up and down arrow
keys (right side of display) for 3 seconds to open the Options menu.
2. Use the down arrow to navigate to "Sensors" and press the blue circle key
(lower left of display).
3. Select the sensor you want to set up and press the blue circle key again.
4. To activate or deactivate the sensor, select "Sens On" with the arrow keys
and press the blue circle key to toggle on/off. Repeat for each sensor as
necessary.
Datalogging Settings
It is important to set the date and time, so you can track when a logged event took place.
1. Press and hold the up and down arrow keys to enter the Options menu.
2. Use the down arrow to navigate to "clock" and press the blue circle key.
3. Use the arrow keys to adjust the flashing field. The blue circle button will save the
setting and move to the next field. Set the month using the arrow keys then press
the blue circle key to move to the date field, then the year field.
4. Time is set on the same screen after the date is set. Use the arrow keys to adjust the hour then the
minute field. Repeat this until the date and time are both set correctly.
5. When the minute field for the time is set, press the blue circle button to go back to the options menu.
6. After setting the date and time select "Logger" in the options menu and press the blue circle key.
7. Set the logging interval using the arrow keys and press the blue circle button to save.
Alarm Settings
1. To set alarm levels you have to enter calibration mode
manually. Press and hold the down arrow and the blue circle
button until you enter calibration mode. The meter will zero its
sensors.
2. After the sensors zero, the unit will prompt you to connect
span gas. Press the power button to skip calibration.
3. Press the power button again to skip setting calibration due
dates, and then press the blue circle button to set alarm levels.
4. Use the arrow keys to adjust the value immediately, as the
next alarm setting will be selected only a couple of seconds
after displaying the first one. Use the arrow keys to set the
Nationwide rental of industrial hygiene and safety instrumentation, from a service that treats you right.
Quick Setup Guide
©2014 RAECO Rents LLC, Bensenville IL. All rights reserved.
135 Bernice Drive, Bensenville IL 60106‐3366
Toll Free (866)736‐8347 Phone (815)464‐6200
Fax (815)464‐8720
www.raecorents.com