Troubleshooting - RC-PRO PRO 15 User Manual

3D Flips
Once you have mastered basic functions,
try out the 3D flip function! Make sure the
drone is at least 3m above the ground
and press the Roll button (as shown), then
move the right lever in the direction of your
intendedflip (Pressing upward will flip the
drone over forward, etc)

TROUBLESHOOTING

Problem
1. The drone is not trimmed
The drone is
2. The drone is not calibrated
instable while
3. The drone's blades are damaged
flying
4. Wind is too strong
1. Controller is turned off
Remote control
status light
2. Battery is incorrectly inserted
does not light
3. Battery has no charge
1. The remote control is not turned on
2. The drone battery is not connected
Can not
3. The remote control frequency has not
Control
paired with the drone
4. Wind is too strong
1. Rotor speed is too slow
The drone will
2. Drone battery is too low
not ascend
3. The blades are not positioned properly
The drone
Improper use of the emergency shutdown
crashed instead
feature.
of land
Reason Approach
1. Perform trimming close to the ground (Page 4)
2. Perform gyroscope calibration (Page 5)
3. Replace the blades according to page 3 diagram
4. Do not fly in windy conditions
1. Turn switch to ON position
2. Check that batteries are inserted correctly
3. Replace the batteries with new ones
1. Turn switch to ON position
2. Check battery connection of the drone
3. Turn the remote control off and on again to reset
the connection
4. Do not fly in windy conditions
1. Push up on the left lever
2. Charge the aircraft battery
3. Refer to the page 3 for proper blades positioning
Make sure you use the auto landing button for
easy landing