RC-PRO PRO 15 User Manual page 5

TRIMMING INSTRUCTIONS
Forward and backward trimming
Left and right trimming
Move left
What is Headless Mode and How to Use it
1. Place the drone exactly in front of you with it's nose pointing
forward and press the "headless mode" button on the remote
control. You are now flying headless.
2. As long as the drone is in headless mode the remote contro
will sound a "beep" sound every few seconds. This sound will
stop as soon as the user will return to normal flight mode.
Speed Control
Speed settings apply to all four directions. There are two speeds. To switch
to Fast Mode while in flight, press the accelerator button on the controller.
A double beep will sound. To return to Regular Mode (recommended for
beginners), press the accelerator button again. A single beep will sound to
signal the switch.
Calibrating the Gyroscope
1. If the gyroscope is not calibrated, the drone will wobble while hovering.
This can be adjusted.
2. Before operation, place the aircraft on a level horizontal surface. Hold
both joysticks of the controller down and outward (as shown) until the
remote issues a double beep. A light will flash on the drone to signal
the reset/calibration.
Emergency Shutdown
If a danger is encountered while flying, Emergency Shutdown can
be issued to immediately stop the drone. With long press the
One-button start button for 2 seconds. This function should not be
performed at high altitudes, as the drone WILL immediately fall
from its position and hit the surface.
Move right
When hovering backwards press this
button to adjust until backward motion
stops.
When hovering forward press this
button to adjust until forward motion
stops.
If drifting to the right while hovering,
press left on directional pad until
corrected.
If drifting to the left while hovering,
press right on directional pad until
corrected.