Rear Panel Connections And Controls Sda-2200 - JBL SYNTHESIS SDA-7120 Quick Start Manual

Rear Panel Connections and Controls SDA-2200

BALANCED XLR AUDIO INPUTS INPUT SWITCHES
TRIGGER IN / OUT
DANTE PORTS
Connect the XLR output of your Allow the SDA-2200 to be configured in
Trigger IN allows the SDA-2200 to be turned ON or OFF by an external
See "Dante Ports" on USB
pre-amplifier. different operational modes.
source. Trigger OUT allows the SDA-2200 to control the power state of other
page"Switching On"
See "Connecting Sources and See "Connecting Sources and For software upgrades only.
connected equipment.
on page EN-11.
Loudspeakers" on page EN-12. Loudspeakers" on page EN-12. See "USB" on page EN-9.
See "Trigger IN/OUT" on page EN-9.
PRE-AMPLIFIER INPUTS SPEAKER TERMINALS RS232 NETWORK POWER – AC PLUG VOLTAGE SELECT
Connect the phono outputs of See "Connecting Sources This connection allows for remote This connection allows for remote Connect the correct Ensure that the voltage
your pre-amplifier. and Loudspeakers" on control from a third-party home control from a third-party home AC plug here. selected matches the local
See "Connecting Sources and page EN-12. automation system or computer. automation system or computer. power supply.
Loudspeakers" on page EN-12. See "Network and RS232" on page EN-9. See "Network and RS232" on page EN-9.
PRE-AMPLIFIER OUTPUT Please read the sections "Placing the Unit",
"Power" and "Interconnect Cables" on page
OUTL and OUTR provide a copy of
EN-6 before connecting your SDA-2200
the signal applied to the IN L and IN
amplifier!
R phono sockets only, not the XLR.
Note: This is a passive output,
no additional filtering or
amplification is applied.
EN-8