Rear Panel Connections And Controls Sda-7120 - JBL SYNTHESIS SDA-7120 Quick Start Manual

Rear Panel Connections and Controls SDA-7120

BALANCED XLR AUDIO INPUTS
DANTE PORTS
Connect the XLR outputs of your
See "Dante Ports" on
pre-amplifier.
page"Switching On"
See "Connecting Sources and
on page EN-11.
Loudspeakers" on page EN-12.
PRE-AMPLIFIER INPUTS SPEAKER TERMINALS
Connect the phono outputs of See "Connecting Sources
your pre-amplifier. and Loudspeakers" on
See "Connecting Sources and page EN-12.
Loudspeakers" on page EN-12.
PRE-AMPLIFIER OUTPUT
OUT1-OUT7 provide a copy of
the signal applied to the IN1-IN7
phono sockets only, not the XLR.
Note: This is a passive output,
no additional filtering or
amplification is applied.
INPUT SWITCHES
Allow the SDA-7120 to be configured
to different input types.
See "Connecting Sources and For software upgrades only.
Loudspeakers" on page EN-12. See "USB" on page EN-9.
RS232
This connection allows
for remote control from a
third-party home automation
system or computer.
See "Network and RS232" on
page EN-9.
EN-7
TRIGGER IN / OUT
Trigger IN allows the SDA-7120 to be turned ON or OFF by an external
USB
source. Trigger OUT allows the SDA-7120 to control the power state of other
connected equipment.
See "Trigger IN/OUT" on page EN-9.
POWER – AC PLUG
Connect the correct
AC plug here.
NETWORK VOLTAGE SELECT
This connection allows Ensure that the
for remote control from a voltage selected
third-party home automation matches the local
system or computer. power supply.
See "Network and RS232" on
page EN-9.
Please read the sections "Placing the Unit",
"Power" and "Interconnect Cables" on page
EN-6 before connecting your SDA-7120
amplifier!
EN