Cim-Link Modules Connecting Multiple Communication Loops - Keyscan CIM-LINK Setup Manual

Figure 3 - CIM-LINK Modules Connecting Multiple Communication Loops
Input A, Input B, Input C, and Input D programmed to fire the output in Building 1.
Input A
ACU
CIM 0
CAN Bus 2
CAN Bus 1
Ethernet
Virtual
Connections
KI-00473E-09-12
Keyscan Inc. A Member of the Kaba Group
ACU ACU
Global
Master
J3 - ON
CIM CIM
CIM-LINK – B
J3 OFF
J4 OFF
See Figure 12 for connections.
Install 1 CIM-LINK on each subordinate communication loop.
Building 3
Communication Loop - Subordinate
Single ACU panel communication loop
requires only a CIM-LINK module.
See Figure 13 or Figure 14 for connections.
Output
(Alarm/CCTV etc.)
OCB-8 or IOCB1616
Master Loop
- install 1 CIM-LINK for each subordinate
communication loop.
CIM-LINK A
- communicates with CIM-LINK – A Building 2
CIM-LINK B
- communicates with CIM-LINK – B Building 3
CIM-LINK – A
See Figure 11 for connections.
J3 OFF
J4 OFF
CIM 0 – serial or network connection to PC with Communication Manager
CIM-LINK to CIM-LINK – NETCOMP only
Communication Loop - Subordinate
Input B
ACU ACU
CIM 0 CIM
CAN Bus 2
CAN Bus 1
All CIMs set as slaves.
Building 1
Communication Loop - Master
1 CIM as Global Master on least busy
ACU.
All other CIMs are slaves.
Building 2
Input C
ACU ACU
CIM CIM
CIM-LINK - A
J3 ON – Group Master
J4 OFF – Group ACU Mode
Input D serial or network
connection to PC
with
Communication
Manager
ACU
CIM-LINK - B
J3 OFF – Global Slave
J4 ON – Single ACU Mode
4