Advertisement
Quick Links
Advertisement
Related Manuals for Vintage Air 491230
Summary of Contents for Vintage Air 491230
- Page 1 ISO 9001:2015 Registered Company 3-Lever Polished Panel Gen IV (491230) O F F D A S H H O T 18865 Goll St. San Antonio, TX 78266 Phone: 800-862-6658 Sales: sales@vintageair.com Tech Support: tech@vintageair.com www.vintageair.com 901230 REV D 06/24/19, PG 1 OF 9...
-
Page 2: Table Of Contents
ECU. Please confirm that your unit has the proper ECU prior to installing the control panel as shown Service Info: below. A replacement ECU can be purchased from Vintage Air if needed. Evacuate the system for 35-45 minutes with system components (Drier, compressor, evaporator and condenser) at a temperature of at least 85°... -
Page 3: Packing List/Parts Disclaimer
Set Screw, 4-40 x 1/8” ** Before beginning installation, open all packages and check contents of shipment. Please report any shortages directly to Vintage Air within 15 days. After 15 days, Vintage Air will not be responsible for missing or damaged items. -
Page 5: Label Installation
Label Installation www.vintageair.com Determine the orientation you want to use, horizontal or vertical, and install the label onto the 3-lever panel assembly. Install the (3) knobs onto the 3-lever panel assembly using the set screws as shown in Figure 1, Page 5. NOTE: If mounting in vertical configuration, replace black oxide set screw with (3) stainless steel set screws, Part #183989. -
Page 7: Control Panel Installation
(Vertical Panel) 183989 10-24 Nylon Locknut SIDE VIEW Figure 1 NOTE: When using a Vintage Air supplied control panel, connect the tan wire from the Gen IV Evaporator wiring harness (232600-VUA) to the factory dash lights to enable panel backlighting. -
Page 8: Wiring Diagram
Wiring Diagram www.vintageair.com 232007-VUR AC ANNUNCIATOR BACKLIGHT POS BACKLIGHT NEG 5V-SW WHT/RED TEMP WIPER WHT/YEL MODE WIPER WHT/GRN FAN WIPER PRE-WIRED VIEWED FROM WIRE SIDE GEN IV ECU 232002-VUA GEN IV WIRING DIAGRAM (IF USED) REV E, 10/6/2017 TEMP MODE PROGRAM * DASH LAMP (IF USED) -
Page 9: Operation Of Controls (Horizontal)
Operation of Controls (Horizontal) www.vintageair.com On Gen IV systems with three lever/knob controls, the temperature control toggles between heat and A/C operations. To activate A/C, move the temperature lever/knob all the way to cold and then back it off to the desired vent temperature. -
Page 10: Operation Of Controls (Vertical)
Operation of Controls (Vertical) www.vintageair.com On Gen IV systems with three lever/knob controls, the temperature control toggles between heat and A/C operations. To activate A/C, move the temperature lever/knob all the way to cold and then back it off to the desired vent temperature. -
Page 12: Packing List
Packing List: Control Panel Kit (491230) www.vintageair.com Qty. Part No. Description 493050 3-Lever Polished Panel 232007-VUR Control Harness, Gen IV Universal 484078 Label, 3-Lever Vertical Magnum Label, 3-Lever Horizontal Magnum 484077 492007 Knob, Streamline Slide POT, Polish 183989 Set Screw, 4-40 x 1/8”...
Need help?
Do you have a question about the 491230 and is the answer not in the manual?
Questions and answers