The Drain Hose At The Siphon Is Blocked; Filter In The Water Supply Blocked - Bosch WAE20067ES Instruction Manual And Installation Instructions

Cleaning and maintenance
en
Refit and screw on the pump cover.
The handle must be in a vertical
position.
Put the service flap back on, lock it
6.
into place and close it.
To prevent unused detergent
Note:
from flowing straight into the drain
during the next wash: Pour 1 litre of
water into compartment II and start the
Empty programme.
The drain hose at the siphon
is blocked
Switch off the appliance. Pull out the
1.
mains plug.
Loosen the hose clamp. Carefully
2.
remove the drain hose; residual
water may leak out.
Clean the drain hose and siphon
3.
connecting piece.
Re-attach the drain hose and secure
4.
the connection point using the hose
clamp.
30
Filter in the water supply
blocked
:
Warning
Risk of electric shock!
Do not immerse the AquaStop safety
valve in water (it contains an electric
valve).
First, reduce the water pressure in the
supply hose:
Turn off the tap.
1.
Select any programme (except
2.
Rinse/Spin/Empty).
Press the Start button. Allow the
3.
programme to run for approximately
40 seconds.
Set the programme selector to the
4.
Off position. Pull out the mains plug.
Clean the filter on the tap:
5.
Disconnect the hose from the tap.
Clean the filter with a small brush.
For standard and AquaSecure
6.
models, clean the filter on the rear of
the appliance:
Disconnect the hose from the rear of
the appliance,
Use pliers to remove the filter and
then clean it.
Connect the hose and check for
7.
leaks.