Detergent Drawer And Housing; Detergent Solution Pump Blocked - Bosch WAE20067ES Instruction Manual And Installation Instructions

Detergent drawer and housing

If there is detergent or fabric softener
residue:
Pull out the detergent drawer. Press
1.
down the insert and fully remove the
drawer from the housing.
To remove the insert: Push the insert
2.
upwards from below with your finger.
Clean the detergent dispenser tray
3.
and insert with water and a brush,
and dry. Also remove any detergent
or fabric softener residue in the
housing.
Fit the insert and lock it in place
4.
(push the cylinder onto the guide
pin).
Push in the detergent drawer.
5.
Leave the detergent drawer open
Note:
so that any residual water can
evaporate.
Detergent solution pump
blocked
:
Warning
Risk of scalding!
When washing at high temperatures, the
detergent solution becomes hot. If you
come into contact with the hot detergent
solution, you may be scalded.
Allow the detergent solution to cool
down.
Turn off the water tap so that no
1.
more water can flow in and has to be
drained via the detergent solution
pump.
Switch off the appliance. Pull out the
2.
mains plug.
Cleaning and maintenance
Open and remove the service flap.
3.
For models:
4.
– With a drainage hose: Remove
the drainage hose from its holder
and remove the sealing cap.
Allow the detergent solution to
flow out into a suitable container.
Replace the sealing cap on the
drainage hose, and place the
drainage hose back in its holder.
– Without a drainage hose::
Carefully unscrew the pump
cover until the detergent solution
begins to flow out.
When the service flap is half full,
close the pump cover and drain
the service flap.
Repeat the above steps until all
the detergent solution has
completely drained out.
Carefully unscrew the pump cover;
5.
residual water may leak out.
Clean the interior, pump-cover
thread and pump housing. The
impeller in the detergent solution
pump must be able to rotate.
en
29