Maintenance; Troubleshooting - Glamox FL60 Series Operating Instructions Manual

de
en

Maintenance

fr
tr
el
es
pt
da
nl
no
sv
pl
cs
hu
FL60S... Maintenance note:

Troubleshooting

Page 18 of 27
This product is low maintenance in design. The tests listed below must be
conducted regularly in order to ensure safety permanently. The maintenance in-
tervals depend on the ambient conditions and are to be defined by the system
operator.
Lamp cover
Threaded cable gland
Heat sink of the individual
modules
Safety labels, rating plates
Table 4 Maintenance work
Figure 12 ( Lamp cover not remove )
Opening the aluminum housing for repair purposes, is only to do
by qualified personnel to perform under suitable climatic conditions. The ingress
of any moisture in the housing is to be avoided ! By breaking off the seal of the
electronics housing, end all warranty claims
Please consult the table below if the product malfunctions. If this does not provide
any remedy, contact the Customer Service.
Malfunctions are often caused by a defective connection or maintenance. The da-
ta in this section must be strictly observed.
Test for
Damage and cracks
Porosity of the sealing ring
at the cable
Impurities, foreign bodies
Legibility and adhesion
02.02.2016
Measure
Replace module
Replace threaded cable
gland
see note chapter
Cleaning (
Cleaning)
Replace labels
7179761000/ Index 03 / DCN 21969