Battery Charging; Setting The Clock (2-Way- Lcd Remote) - CrimeStopper SP-302 Operating Instructions Manual

The 2-Way LCD Pager remote transceiver is used to send and receive information from
Module transmits High Frequency FM signals from the vehicle to your pager over long d
will vary depending on location, terrain, and local RF noise/interference. This system is n
you if you are behind concrete walls, underground, in a large structure, or in an area with
electronic interference. Handle the pager/remote with care. The LCD display and/or the
damaged if subjected to abuse.
The 2-Way LCD remote has a battery charge indicator on top right corner of displa
affects the distance of the remote control. The system comes with a standard Mi
that plugs into the side of remote control. To access to USB plug, slide the co
below.
1. Press VEH Button on the side of the remote control 5 times.
2. The remote will beep and the AM or PM display will begin flashing.
3. Press the Trunk Button to go to the next item – AM - PM - Hour- Minutes.
4. Press the Lock Button to Increase time.
5. Press the Unlock Button to decrease time.
6. Press the PANIC Button to Disable or Enable Beep and Vibration. See next pag
7. Press the VEH Button to Save and Exit Setup or wait 8 seconds, the LCD light wi
All manuals and user guides at all-guides.com
USING THE 2-WAY PAGER TRANSMITTER

BATTERY CHARGING

SETTING THE CLOCK (2-WAY- LCD REMOTE)

4
USB Ch