olympia electronics SLIM LIGHT Series Manual

GR-2000
OPERATION VOLTAGE
MAXIMUM POWER CONSUMPTION
BATTERIES Ni-Cd ( )
BATTERY PROTECTION
INDICATIONS CONTROLS -
CHARGING TIME
AUTONOMOUS DURATION
ILLUMINATION SOURCE
ILLUMINATION SOURCE INTENSITY
DEGREES OF COVER PROTECTION
PRODUCED IN ACCORDANCE WITH
OPERATION TEMPERATURE RANGE
RELATIVE HUMIDITY
CONSTRUCTION MATERIALS
EXTERNAL DIMENSIONS
TYPICAL WEIGHT
GUARANTEE
GENERAL
The luminaires of this type cover
functionality in security lights, for professional
or household use.
They have features such as:
1. Change function from
non-maintained or vice versa, whenever
desired.
2. Light sensor to select the activation or not
of the l uminaire, when it is connected to the
mains power supply,
lighting in the area.
3. Dimming control
4. Possibility of remote control
functions and additional functions are
analyzed on page 3.
The functions 1,2 and 3 may be
using the TEST button as explained on page
3.
T h e l u m i n a i r e m u s t b e p e r m a n e n t l y
connected to the mains
normal operation it
lights the LED lighting (
a n y p o w e r f a i l u r e t h e l
automatically switched to
lighting the LED lighting
When the mains power supply is restored the
unit returns to normal operation.
Charging the Battery
The charging of the
by the luminaire to achieve optimal battery
maintenance, and prolong
battery is fully charged, the charging current is
limited for maintenance.
Page 1 from 4
'' SLIM LIGHT '' SERIES FOR MAINTAINED / NON-MAINTAINED
TECHNICAL CHARACTERISTICS
Charge (green), lamp fault (red), fault (orange) indication LED TEST button
EN 60598-1, EN 60598-2-22, ÅÍ 55015, ÅÍ 61547, ÅÍ 61000-3-2, ÅÍ 61000-3-3
the standard
maintained to
if there is adequate
(with remote control ).
for
implemented
power supply . During
charg es the battery and
maintained mode). In
u m i n a i r e
emergency
from the battery.
battery is fully controlled
ed life. When the
(OPTIONAL) LUMINAIRE
220-240V AC/50-60Hz
From overcharge and full discharge
3-7 hours depending on the illumination adjustment of the LED's
110lm (230V AC) / 110lm (emergency)
Bayblend F 3010 transparent polycarbonate R
270 x 100 x 25 mm
3 years
Battery cut off
The luminaire enters
power supply
lost all its energy. The consumption of all
lighting circuits is limited to the minimum
needed to protect the battery from deep
discharge.
Manual Test
Manual testing
Test button
driv ing circuit . To
unit should be
supply and the battery
these During the test
Automatic
It includes
automatically every 15 days. To
operation,
mains power supply
enabled.
Automatic
The automatic duration test
autonomy of the emergency operation of the
i s device. This
mode, every 6 months. To
unit should be
supply and the battery
f u l l y c h a r g e d , o t h e r w i s e t h e c h e c k i s
postponed
Backup Status Operation
The duration
is at least
During the backup operation
also performed
4W
3.6V/1Ah
24h
White LED's
IP 40
o
0 to 40 C
Up to 95%
,
340gr.
(1 year for the battery )
this state when the mains
is interrupted and the battery has
is performed by pressing the
to check the LED lighting and the
perform this operation,
connected to the mains power
must be enabled
the orange LED
LED Test
all manual tests but
the unit should be connected to the
and the battery
duration test
test is performed automatically
perform this operation,
connected to the mains power
must be enabled
until the battery is fully charged.
of battery life in emergency
that specified in the table above.
.
923200000_09_003
S A A R CE RT
CERTIFICATE
VALID SYSTEM
EN ISO 9001 : 2008
,
the
.
blinks .
is conducted
perform this
must be
measure s the
the
and
mode
an LED test is