Advertisement
Surface Mount Wall Box
Separate the wall box cover and base.
Remove the rectangular knockout in the center of the base only if the tamper switch will
not be used.
Drill an opening in the wall through which the wires will be routed.
o If using the tamper switch, drill a hole for the wires ensuring the hole will not
interfere with the operation of the push button tamper switch.
Mount the base onto the wall over the wire opening using the supplied metal screws and
plastic anchors.
Mount the DK-38 to the cover using tamper resistant #6 screws (recommended) or #6
conventional screws. Program the unit prior to securing in place.
Pull wires through the wall/center of the base and connect to the DK-38 wiring terminals
per instructions in the Wiring section of this document.
Push the wall box cover onto the base until it snaps into place.
Flush Mount Wall Box
Cut out an opening in the wall into which the box will be mounted.
Route wiring through one of the four knockouts in the back of the box.
Push the box into the wall and secure in place using the two swing clamps.
Connect wires to the DK-38 wiring terminals per instructions in the Wiring section below.
Program the unit prior to securing in place.
Mount the DK-38 to the box using tamper resistant #6 screws (recommended) or #6
conventional screws.
DK-38 Wiring
1
2
3 4 5 6 7 8 9
Wiring Terminals
Tamper Switch
Beeper
Each terminal is provided
with a marking
for easy reference.
Feedback and Entry Overview
The DK-38 comes with LED indicator lights above the keypad; green, yellow, and red. These
three indicator lights and the backlight provide feedback during operation. When the DK-38 is in
Wiegand mode there is no yellow feedback light when connected to an access controller. The
yellow light is designed to work with the Securitron DKC Digital Keypad Controller. The three
indicator lights are intended for operation through an access controller either through a dry-
contact connection to ground or an open-collector driver. Please refer to the access controller for
information about the meaning of the indicator lights. The table below is only for use with
Securitron DKC controller.
Wiring Terminal Connections
DK-38
DK-38 Wiring
Terminal
Reference
Positive DC supply
DC+
lead
D0
Wiegand data zero
D1
Wiegand data one
GRN
Green light
RED
Red light
YEL
Yellow light
BUZ
Audible buzzer
TAMP
Tamper indicator
GND
Ground
Note that suggested wire color for 'YEL' terminal is
BLUE and suggested wire color for 'BUZ' terminal is
YELLOW
Page 2
Suggested
Wire Color
Red
Green
White
Orange
Brown
Blue
Yellow
Purple
Black
PN# 500-20760
Rev. A, 06/13
Advertisement
