DAHON CIAO Manual page 8

TranzX PST sensor calibration
Once you have finished assembly of the bicycle, please kick up the
kickstand and make sure the two wheels stand in a straight line before
resetting the display. Turn on the power button and press the Back
Light Button for 6 seconds, until the display shows "CAL X" for a few
seconds. This calibrates the TranzX PST sensor. After this step,
you can start to ride your bicycle.
Note:
If you change the display or remove or adjust the rear wheel,
make sure you recalibrate the sensor of the TranzX PST.
Final Check
After completion of assembly, please perform a final check
and make sure that:
1. Every bolt and screw is tightened properly.
2. Tires are inflated to the recommended tire pressure.
3. Brakes are functioning properly.
Note:
1. Fold your Dahon E-bike according to the manual.
2. When folding and unfolding please take care to check that the internal cables are
not caught. Should this occur, simply push the two cables back inside the frame.
08