SODEX S14115EZW Assembly Instructions Manual

ADRESS
SODEX INTERNATIONAL
18 rue de l'Avenir - Bât. 224
14650 CARPIQUET
Tel : + 33 (0) 2.31.53.78.70
Email: karine.chaigneau@sodexinternational.com
DESCRIPTION
Steel structure
Zinc plated-powder coated
CONFORMITY
European Standards
NF EN 1270
SPORTS LAW 2007
COMPLY WITH SPORTS LAW 2007, THE GOAL IS REQUIRED TO BE FIXED BY ANCHOR SYSTEMS WHEN
USING.THE GOAL MUST BE SUBJECT TO A TEST OF RESISTANCE TO THE VERTICAL WITH 320 KG
'BETWEEN THE BACKBOARD & RING DURING 1 MINUTE BY HODLING TEST MACHINE AT A HEIGHT OF
20CM.
In the first installation, this test of stablilty and solidity of the goal is obligatory.
On each use, a visual control of stability and of solidity of the goal must be executed.
The equipment 's owner must regularly check the current status of the goal.
Equipment must be maintained regularly by the owner, it's recommended for good use:
- Verify weekly the good tightening of screws
- Repaint on positions where can be impacted with the kind of paint that is specified by the manufacturer
- All damaged parts must be replaced immediately by a separate part exclusively for this product and are notified
by the manufacturer.
- Clean the equipment using diswashing liquid, clean water and a soft dishcloth.
This product is warranted for one year for parts and labor. Every request about the equipment status shall be done
within the legal delay since the receipt.
Warranty excludes :
- Any damage during the transportation
- Any damage due to different use from the purpose of the product design
- Any damage due to poor maintenance
- Defective product not notified within the legal delay
- Any damaged caused by wrong assembly (not conform to the assembly instructions of the manufacturer)
THIS EQUIPMENT HAS BEEN MADE AND DESIGN APPLYING THE EUROPEAN STANDARD NF EN 1270.
RÉF. PRODUCT
SPORTS LAW 2007
MAINTENANCE OF EQUIPMENT
WARRANTY
ASSEMBLY INSTRUCTIONS
WALL MOUNTED
BASKETBALL GOAL
S14115EZW UNIT