Advertisement
11
model number 060-1901-6 | contact us: 1.866.523.5218
conpletely stop.
-Turn the dethatcher over.
-Use a hex key (not supplied) to loosen the two screws. (See D1)
-Take out of the plastic cover. (See D2)
-Lift up the rake wheel a little and pull the rake wheel out of the machine. (See D3)
5. REPLACE THE TINES
If the tines are broken/missing, then follow steps below to replace.
- Use a hex key wrench to take out two screws and remove plate covering; (See D2, D3)
- Take out the screw inside the tine reel; (See E1)
- Remove the bearing and then bushing; (See E2)
- Slide spring wheels off the reel until the desired spring replacement is reached; (See E3)
- Remove the spring wheel that needs replacement; (See E4)
- Place new spring into the wheel, pay attention to keep the same direction with other spring;
(See E5)
- Assemble the rest of the spring wheels taken out before, pay attention to the location of shaft
and wheels; (See E6)
- Assemble the bushing and then bearing, and re-tighten the screw; (See E7)
- Assemble the wheel to the unit. (See E8)
HOW TO USE YOUR DETHATCHER
Observe all the relevant warnings when using your dethatcher.
1. To look after a lawn properly, you need to do more than just once a year.
2. Do not force your dethatcher through grass that is too long.It is recommended that your
dethatcher should not be used in grass that is longer that 3" (7.5 cm).
3. Do not use in wet or damp conditions.
4. To obtain the best result from your dethatcher use it regularly. It is recommended that your
dethatcher is used at the beginning and the end of each grass cutting season.
Advertisement
