Advertisement
10
model number 060-1901-6 | contact us: 1.866.523.5218
Read operator's manual
Intended Use
This dethatcher is intended for domestic, dethatching of lawns.
This dethatcher is not intended for use on stones and other hard materials.
!
WARNING: To avoid injury from unexpected starting or electrical shock during assembly
or adjustment, do not plug the power cord into a source of power.
1. ASSEMBLING HANDLES
Installing the lower handle
- Insert the lower handle into the housing hole. (See A1)
-Align the holes and use supplied screws to fasten the lower handle to the housing.(See A2)
Installing the upper handle
- Position the upper handle so the holes line up with the lower handle holes.
-Align the square holes in lower handle and upper handle
- Insert the supplied hex bolt through the hole from the inside of the handle bar. (See A3)
- Thread the knob onto the hex bolt to tighten securely into place.
NOTE: Install the extension cord retainer to upper handle with wire side before installing
the upper handle with lower handle.
2. STARTING AND STOPPING (See B)
To start:
-Plug the dethatcher into an approved outdoor extension cord.
-First press and hold the safety lock-out button. And then pull the switch lever on the handlebar
to operate.
To stop:
-Release the bale switch.
Stopping the dethatcher
-Release the switch lever.
3. EXTENSION CORD RETAINER (See C1,C2, C3)
After securing the extension cord, use the extension cord retainer to prevent the extension
cord from disconnecting from the power cord when the dethatcher is in use. Attach cord
retainer to dethatcher handle.
4. REPLACE THE RAKE WHEEL
If the rake wheel is worn and tines are broken/missing, then replace the rake wheel
assembly. The new individual rake wheel is sold separately.
-Disconnect the dethatcher from the power source. Allow sufficient time for moving parts to
Advertisement
