Table of Contents
Advertisement
INSTALLATION AND INITIAL SETUP
If either of the two Ethernet ports will not be used, the unused port must be configured as follows:
• Do not connect the unused port to a network switch
• Using the steps above, navigate to the IP Configuration screen of the unused port
• Set "Use DHCP" to "Yes"
• Highlight and select "Update"
• Power cycle the unit
Pressing the Right/Left buttons will eventually return you to the Home Screen.
Connecting Inputs and Outputs
Connect inputs and outputs as required for your particular installation. ARC can access any of the eight
audio pairs carried on an incoming HD- or SD-SDI stream and provide de-embedding and pair shuffling
at its input. Audio can also be received using the AES-3 input or via AES67. Details instructions on audio
routing are provided in the full ARC user manual.
Figure 4: IP configuration screen for Control port
Advertisement
Table of Contents
