Cisco Catalyst 9200 Series Installing Manual page 7

Network module

Hide thumbs Also See for Catalyst 9200 Series:

Installing a Network Module

Figure 4: Installing a Transceiver Module in the Uplink Module Slot

Removing a Cisco Pluggable Transceiver Module

Procedure

Step 1

Attach an ESD-preventive wrist strap to your wrist and to an earth ground surface.

Step 2

Disconnect the cable from the transceiver module. For reattachment, note which cable connector plug is send

(TX) and which is receive (RX).

Step 3

Insert a dust plug into the optical ports of the transceiver module to keep the optical interfaces clean.

Step 4

If the module has a bale-clasp latch, pull the bale out and down to eject the module. If you cannot use your

finger to open the latch, use a small, flat-blade screwdriver or other long, narrow instrument to open it.

Step 5

Grasp the transceiver module and carefully remove it from the slot.

Step 6

Place the transceiver module in an antistatic bag or other protective environment.

Removing a Cisco Pluggable Transceiver Module

Installing a Network Module