Advertisement
TN198 Page 9 of 11
Continue to re install the Engine tray. Tighten the fixing screws to the rear panel of the engine once it
is fully home.
Next re connect the Video, Local I/O and Linkport ribbon cables, via the hole in the PC base plate
floor. This sometimes a little awkward, do not try to rush this.
Carefully fit spiral wrap to the optical cables in the top of the engine to ensure these are secured
neatly out of the way, as shown in the pictures above.
Screw down the engine tray with the internal fixing screws and re-fit the fan panel making sure that
the fan power is connected.
Replace the engine lid and re fit the engine into the console.
Repeat whole procedure for second engine
See next page for Software Upgrade Instructions
TN198.doc\
Advertisement
