Display Assembly; Removing The Display Assembly - Dell Inspiron 7405 2n1 Service Manual

Steps
1. Align and place the power button, along with its cable, on the slot of the palm-rest and keyboard assembly.
2. Slide the power-button cable into the connector on the fingerprint reader-board and close the latch to secure the cable.
3. Connect the fingerprint reader-cable to the connector on the I/O board and close the latch to secure the cable.
4. Connect the I/O-board cable to the connector on the I/O board and close the latch to secure the cable.
5. Adhere the tape that secures the I/O-board cable to the I/O board.
6. Align the screw holes on the power-button bracket with the screw holes on the palm-rest and keyboard assembly.
7. Replace the two screws (M2x3) that secure power-button bracket to the palm-rest and keyboard assembly.
Next steps
1. Install the fan.
2. Install the heat sink.
3. Install the base cover.
4. Follow the procedure in

Display assembly

Removing the display assembly

Prerequisites
1. Follow the procedure in
2. Remove the base cover.
About this task
The following image indicates the location of the display assembly and provides a visual representation of the removal procedure.
40 Removing and installing components
After working inside your computer.
Before working inside your computer.