Korg XE20 Owner's Manual page 17

Turning the reverb on/off
This switches the reverb (an effect that make the sound linger)
on/off.
1.
Press the REVERB button.
When you press the button while reverb is being applied,
the reverb will shut off.
When you press the button while reverb is not being
applied, the reverb will be turned on.
Note:
Some keyboard sets do not use a reverb effect, and
you will not be able to apply reverb for these sets.
This setting will be lost when the power is turned off.
Applying effects
Each keyboard set contains two effects (effects 1 and 2), which
change the final output depending on the amount of sound that
is sent through the effects (the send level).
Note:
Depending on the type of effect, the change in sound
may not be too noticeable.
1.
Press the SETTING/[MEDIA] button.
2.
Press the CATEGORY button t/u to select from the
P14–21 effects (for effect 1 or 2) and the part to which the
effect will be applied (lower, upper 1–3), on the screen.
1
3.
Use the dial or the +/– buttons to set the effect send level.
When the send level is at "0", the effect will not be heard.
The greater the send level, the more you will hear the effect.
4.
Press the [SHIFT] button to return to the previous mode.
Tip:
If you want to save your settings, save them as a set list.
Selecting an equalizer (EQ)
You can add an equalizer effect to make the sound outputted
from the built-in speakers easier to listen to, or to adjust the
tonal character of the sound to match the musical genre you are
playing.
1.
Press the SETTING/[MEDIA] button.
2.
Press the CATEGORY button t/u to select "P12:Speaker
EQ".
3.
Select the equalizer using the dial or the +/− buttons.
There are eight types of speaker EQ:
Standard " Bass Boost " Bass Cut " Treble Boost " Treble
Cut " Mid Boost " Mid Cut " Loudness " Standard ...
(The default setting is "Bass Boost.")
4.
Press the [SHIFT] button to return to the previous mode.
Tip:
If you want to save your setting, save it as a set list.
1
3
2
3
Playing the XE20 (style mode)
17