General data ...................................................................................................................................................... 1
Parts list ............................................................................................................................................................. 2
Assembling the frame ....................................................................................................................................... 4
Jumping bed assembly ...................................................................................................................................... 6
Attaching the banners ........................................................................................................................................ 7
• over-extended and tired springs / rubber cables are to be replaced; • the important thing is that the springs are always hooked in with the eyelet pointing downwards. Eurotramp - Trampoline Kurt Hack GmbH...
Spring clip Mounting tool All spare parts available from Eurotramp upon request. The very highest demands are placed on this high-end-product. For safety reasons, only use original replacement parts! The use of non-original replacement parts can result in considerable risk to the user (danger of accidents, technical defects, loss of the manufacturer’s liability, loss of warranty etc.).
• To mount the remaining part you need to pull apart the frame by a little. It might be helpful not to slide any of the frame parts all the way in at first. Eurotramp - Trampoline Kurt Hack GmbH...
Page 6
• Do not tigh the steel cables yet! • Mount the legbraces to the round sleeves. • Tight the screws. • Tighten the steel cables „hand-tight“ with the turnbuckle and tighten the lock nuts. Eurotramp - Trampoline Kurt Hack GmbH...
Put three webs on each side of the hook. Only in the corners there will be 4 webs on one side of each last hook. If the loop of the very last web is too small it can be neglected. Eurotramp - Trampoline Kurt Hack GmbH...
(close to the outer edge) and fix the banner on the Velcro. Put the round steel bars into both sides of the hemstich in the lower side of the banner. Eurotramp - Trampoline Kurt Hack GmbH...
The complete disassembly of the Fivesquare is to be made in reverse order of the assembly. If you have any questions, contact us any time: Eurotramp Trampoline - Kurt Hack GmbH Zeller Str. 17/1 | 73235 Weilheim +49 (0)7023 - 9495-0 welcome@eurotramp.com www.eurotramp.com...