Table of Contents
Advertisement
Jumping bed assembly (with the graphics side facing up)
The jumping bed should preferable be attached by 2 persons.
Eurotramp - Trampoline Kurt Hack GmbH
1
Required material
•
Mounting tool
•
Safety gloves (not in scope of delivery)
•
Hang in 2 steel springs per corner first of all to
fix the jumping bed.
2
•
Install the jumping bed with two springs on
each corner. The graphics of the bed should
face upward.
3
•
Install the hooks to the jumping bed and
always put a rope loop in the middle of each
hook. Put three webs on each side of the
hook. Only in the corners there will be 4 webs
on one side of each last hook. If the loop of
the very last web is too small it
can be neglected.
6
Advertisement
Table of Contents
