Troubleshooting - Yamaha FINO AF115F Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
3. Remove the turn signal light bulb
socket by turning it counterclock-
wise.
ZAUU1020
1. Rear turn signal light bulb (× 2)
4. Remove the burnt-out bulb from
the socket by pulling it out.
5. Insert a new bulb into the socket.
7
NOTICE
_
If a turn signal light bulb of different
wattage than recommended is used,
the turn signal light flashing may be
affected.
_
6. Install the socket into its original
position.
7. Install the panel, and then securely
close the seat.

Troubleshooting

Although Yamaha motorcycles receive
a thorough inspection before shipment
from the factory, trouble may occur dur-
1
ing operation. Any problem in the fuel,
compression, or ignition systems, for
example, can cause poor starting and
loss of power.
The following troubleshooting chart
represents a quick and easy procedure
for checking these vital systems your-
self. However, should your motorcycle
require any repair, take it to a Yamaha
dealer, whose skilled technicians have
the necessary tools, experience, and
know-how to service the motorcycle
ECAU0080
properly.
Use only genuine Yamaha replace-
ment parts. Imitation parts may look
like Yamaha parts, but they are often
inferior, have a shorter service life and
can lead to expensive repair bills.
EAU25851
_
When checking the fuel system, do
not smoke, and make sure there are
no open flames or sparks in the ar-
ea, including pilot lights from water
heaters or furnaces. Gasoline or
gasoline vapors can ignite or ex-
plode, causing severe injury or
property damage.
_
7-30
WARNING
EWA15141