The following items should be included: Control Unit Tool Cable ...... 1 unit Power Cord ....1 unit for Robot ......1 unit Ref. 0021403 Ref. 0009401 Ref. UCR470-5A Communications Manual ......1 unit Cable ....... 1 unit Ref. 0020996 Ref. 0020261 w w w.jbctools.com Control Unit for Robot Ref.
Page 4
Current usage leads to overloading Due to overload wait until the device has cooled down 7 times Shortcircuit Check if the cartridge is compatible with the station 12 times Memory error Reset the station If the error persists, contact with JBC technical service.
Page 5
Connection - The UCR470-5A control unit for robot can be connected to a PLC by a five-pin communications cable connector (Ref. 0020261). - For a proper connection, it is only necessary to connect three of the five pins to a typical DB9 male connector (PLC or computer).
Page 6
Dimensions Dimensions in mm (Dimensions in in)
Compatibility The Control Unit for Robot UCR470-5A works with TR470-A and TRA470-A devices and its cartridge range R470. Connect any of those tools with the provided cable (Ref. 0021403). Find more information in www.jbctools.com Ref. TR470-A Ref. TRA470-A Maintenance - Before carrying out maintenance, always allow the equipment to cool down.
Page 8
Safety It is imperative to follow safety guidelines to prevent electric shock, injury, fire or explosion. - Do not use the unit for any purpose other than soldering or rework. Incorrect use may cause fire. - The main cable must be plugged into approved bases. Make sure that it is properly grounded before use.
Page 9
有害物质含量表 w w w.jbctools.com 产品中有害物质的名称及含量 有害物质 部件名称 六价铬 多溴联苯 多溴二苯醚 铅(Pb) 汞(Hg) 镉(Cd) (Cr(VI)) (PBB) (PBDE) 烙铁头 手柄 电源线 主机 电源插座 保险丝 主开关 电位连接 变压器 线路板 O 表示该有害物质在该部件所有均质材料中的含量均在GB/T 26572 规定的限量要求以下。 X 表示该有害物质至少在该部件的某一均质材料中的含量超出GB/T 26572 规定的限量要求。...