Janome Continental M7 Professional Instruction Book page 10

z
x
z x
t
r
w
q
w
q
y
Adjusting the horizontal position of the thread cutter
switch
z Loosen the setscrews q under the switch.
q Setscrew
w Washer
x Slide the switch to left or right, and fix it at the
desired position by tightening the setscrews with a
screwdriver.
Adjusting the vertical position of the thread cutter
switch
z Remove the setscrews q and washers w.
x Move the switch to forward or backward, and attach
the switch to the desired position e and fix it
with the setscrews q and washers w.
e
NOTE:
To fix the thread cutter switch to its lowest position, fix
the setscrews into the hole r, and then holes t.
Tighten the setscrews securely.
Peel off the backing paper from the rubber sole y
and attach it to the bottom of the thread cutter switch
as shown.
8