Knee Lifter Lever - ELNA 7100 Servicing Manual

q
7.5 mm
w
e
10

13. Knee Lifter Lever

The presser foot rises 7.5 mm when it is fully raised with
the knee lifter.
z Remove the base and lay the machine on its back.
x Loosen the nut q on the knee lifter lever w slightly
and turn the adjusting screw e to adjust the height.
• If it is lower than 7.5 mm, turn the adjusting screw e
clockwise.
• If it is higher than 7.5 mm, turn the adjusting screw e
counterclockwise.
c Tighten the nut q firmly and attach the base.
NOTE:
Lower the needle bar to the lowest position and check if
the needle cramp does not hit against the presser foot
when it is fully raised.