LG LMNC182BHA0 Installation Manual page 18

Installation of Indoor, Outdoor Unit
Wired remote controller installation
• Since the room temperature sensor is in the remote controller, the remote controller box should be installed
in a place away from direct sunlight, high humidity and direct supply of cold air to maintain proper space
temperature.
Install the remote controller about 5ft(1.5m) above the floor in an area with good air circulation at an
average temperature.
Do not install the remote controller where it can be affected by:
- Drafts, or dead spots behind doors and in corners.
- Hot or cold air from ducts.
- Radiant heat from sun or appliances.
- Concealed pipes and chimneys.
- Uncontrolled areas such as an outside wall behind the remote controller.
- This remote controller is equipped with a seven segment LED. display. For proper display of the remote
controller LED's, the remote controller should be installed properly as shown in Fig.1.
(The standard height is 1.2~1.5 m from floor level.)
WIRING CONNECTION
• Remove the control box cover for electrical
connection between the indoor and outdoor
unit.
(Remove screws ¿.)
• Use the cord clamper to fix the cord.
18 Air Conditioner
AUTO SWING OPERATION SET TEMP FAN SPEED SUB FUNCTION
Room Temp
HI AUTO Heater Preheat
MED JET Defrost Humidify
LO Filter Out door
Time ZONE 1 2 3 4
Timer Operation unit Program set
On Off
Set no. Time 01 03 05 07 09 11 13 15 17 19 21 23
no
N
TIO
B FU NC t
SU Pre ify hea
D ate r mid r
EE He t Hu t doo
N SP AUT O fros De Ou 4
FA JET er Filt 3
MP HI 2
T TE p MED 1
SE m Tem LO 23
N Roo NE
IO AT ZO 21
ER 19
OP e 17
ING Ti m 15
SW m set
TO gra 13
AU Pro 11
09
t 07
tion uni
Op era 05
03
m er f 01
Ti Of Tim e
On no.
Set
no
Fig.1 Typical locations for remote controller
yes
AUTO SWING OPERATION SET TEMP FAN SPEED SUB FUNCTION
Room Temp
HI AUTO Heater Preheat
MED JET Defrost Humidify
LO Filter Out door
Time ZONE 1 2 3 4
Operation unit Program set
On Timer Off
Set no. Time 01 03 05 07 09 11 13 15 17 19 21 23
no
5feet
(1.5meters)
Control terminal board
Control box
1
Control box cover
(On which the Electric
Wiring Connection is put)
A A view
Remote
1 control cord
Cord clamper
Connection
cord between
the indoor unit
and the
outdoor unit