To Stop The Engine - Husqvarna 323S15 Operator's Manual

1. Press the primer (6) at the bottom of the carburetor a
few times with your fi nger until the fuel starts to fl ow
through the transparent pipe.
NOTE
• There is no need to operate the primer when restarting
immediately after stopping the engine, provided there
is fuel left in the fuel tank.
2. Lift the choke lever (7) on the right of the air cleaner
until it is in the "closed" position.
NOTE
• When restarting immediately after stopping the engine,
set the choke lever to "open".
• DO NOT close the choke when starting a warm engine.
A warm (hot) engine can be:
- an engine that has just stopped running.
- an engine in hot ambient temperatures.
3. Move the throttle lever to 1/2 from the "idle" position.
DO NOT increase throttle lever until the unit is on the
operators back and the unit is ready for spraying.
4. Place the sprayer in a stable location, and pull the
starter knob with the right hand while holding the
sprayer tank down with the left hand. The starter knob
should fi rst be pulled out lightly, then, when resistance
is felt, pulled more swiftly and vigorously.
6
• Do not pull the rope out completely or release the
5. After the explosion is heard, place the damper bar to
6. Once the engine has started, fully open the choke lever
7
• If the rope is pulled continuously with the choke closed,

To stop the engine

• Stop the engine immediately in the event of an emer-
1. Lower the throttle lever (12) fully and cool the engine
2. Hold down stop switch (11) on the left side of the spray-
NOTE
starter knob so that the rope returns, as this can cause
starter malfunction.
"half open" position.
(7), warm up at idling for 2-3 minutes.
NOTE
the spark plug may become fl ooded and the engine
may fail to start. If so, you should fi rst remove the
spark plug and dry the electrodes, then repeat the
starting procedure.
WARNING
gency.
down for 1-2 minutes at low speed.
er frame until the engine has come to a complete stop.
323S15/25
7
GB-39