Summary of Contents for Automatic Products SNACKSHOP 111 Series
Page 1
$3.00 SNACKSHOP 111-112 SNACKSHOP 111-112 SNACKSHOP 111-112 SNACKSHOP 111-112 SNACKSHOP 111-112 instruction manual for SNACKSHOP 111-112 75 WEST PLATO BOULEVARD • ST. PAUL, MINNESOTA 55107-2095...
Page 2
EXPRESS WARRANTY Automatic Products international ltd. (APi) expressly warrants these automatic merchandisers (the “Unit”), manufactured by it, to be free under normal use and service from defects in material or workmanship for a period of two (2) years from the date of delivery of this Unit to the original purchaser. This warranty extends only to the original purchaser of the Unit.
Snackshop 111 and 112 have been designed from superior engineering and with quality throughout.They have been built of rugged construction for many years of reliable trouble-free operation. Note: (For indoor use only) To achieve the most economical trouble-free operation from your Snackshop 111 and 112, it is recommended that this service manual be thoroughly read and instructions follo wed pertaining to all loading and servicing, etc.
112 capacities Unless otherwise specified, machine will be shipped with spiral assortment shown below. Figures in circles represent capacities in each spiral.
unpacking The Snackshop 111 and 112 are assembled and packed so 4. Removing Vendor Without A Fork Lift Truck: Remove the that a minimum amount of time is necessary for preparation to carton from the vendor. Remove 1/4 “ piece of plywood install it on location.The following steps are recommended to located just behind the front legs, then open the door on the insure correct unpacking.
Page 10
installation REMOVAL OF SPIRAL: Grasp the front of the spiral and turn it clockwise. Lift the spiral up and off of the spiral lock.When replac- ing a spiral attach it around the tab on the spiral lock and turn the spiral counterclockwise to lock it in place.
Page 11
installation PRODUCT SPACERS—4 SELECTION SHELF: A product spac- These spirals are removed and installed the same as the large er is used to reduce the width of the product area and should be sprial (see Figure 3), except that the front end position is different used on any 4-selection snack shelf where the product width is (approximately 5 o’clock) (see Figure 5) and the front left side of 41/2 “...
Page 12
installation Figure 7. LOCATION OF PRODUCT PUSHER ON SPIRAL. Figure 8. FOLD BAGGED ITEMS BOTTOM BAGGED OR BOXED ITEMS in the 8-selection shelves if not EDGE FORWARD AND UP. loaded properly could be a problem.The sealed edge of the bag may get under the spiral wire causing the product to hang up after it has been vended.
components is turned off, the information is retained so that the coin mecha- 1. POWER SUPPLY The 115 volt power cord from the wall outlet comes into the nism and bill validator continue to operate properly. machine and plugs into the bottom of the main junction box locat- The scrolling display will reflect the current inventory as coins are ed to the right of the swing out panel.
Page 14
components inserted, will register the amount on the digital display. When a “Have A Nice Day” to any message you want to program. selection is made the amount on the digital display will deduct the Alternative languages are also available by pressing #4-#10-#1 price of that selection.At this time the total cash will be displayed for English;...
Page 15
components Step #2 – Press the “G” button once and “STOP” will appear. Display Shows: Enter the stop time (NOTE: The “STOP” time is set for the “0” meaning “OFF” machine to go back to full price of the products). “1”...
components feature.) The machine can be programmed to be turned off and both sides of the arrowhead (Example: B2 - B2) the selection will then back on in four different time periods (A, B. C and D) and any run twice. day of the week.
components HAND. DAMAGE TO THE MOTOR WILL RESULT. It is also important to check polarity before applying current to the motor. Two diodes and a capacitor are used to prevent circuit feedback and may have to be checked when trouble shooting motor prob- lems.
The 115 volt harness can be the vendors are wired with a fan plug on the junction box for easy ordered from Automatic Products under part #680475. The 24 installation. volt harness can be ordered under part #680355. ARDAC valida-...
Page 20
door - outside front Item Item Item Part No. Part No. Description Description Part No. Description 340044-10 Top Trim Vantage. 420071 Ace Lock W/2 Keys. 201690-3 Top Trim Insert. True Grit Black. 420071-1 Ace Lock W/1 Key. 201690-14 Top Trim Insert. Dark Gray. 420071-2 Ace Lock W/O Key.
Page 22
door - inside front Item Item Item Part No. Part No. Description Description Part No. Description 600599 Door Only. Specify Color. 276-8R6 Screw, Pan Hd.Phil. Type 23 #8-32 x 3/8. 600599-1 Door Only. European Style. Specify Color. 750141-1 Front Window. (44 5/8 x 21-9/16 x 1/8) 600599-2 Door Only.
Page 36
gum & mint shelf Item Item Item Part No. Part No. Description Description Part No. Description 660317 Assembly Complete. Gum & Mint Shelf. 111. 680306 Harness, Gum and Mint Shelf. 660317-2 Assembly Complete. Gum & Mint Shelf. 112. 660341 Harness, Gum and Mint “/bracket. 380229 Gum and Mint Shelf Plug Only.
Page 38
delivery bin Item Item Part No. Description Part No. Description 660558-4 Delivery Bin Assembly. Alliance. 440129 Door Bearing. 660558-1 Delivery Bin Assembly. Complete. Black. 420282 Bin Door Washer. 660558-3 Delivery Bin Assembly. Complete. Gray. 200763-1 Inner Door. 600704-1 Delivery Bin. 200763-4 Inner Door.
AP II style Item Item Part No. Part No. Description Description 340044-15 Trim, Top, For use w/Vinyl Insert 440258-9 Insert Top Trim “Snacks” 340057 Trim, Outside Vertical (Right or Left) 340058-2 Trim, Inside Vertical (Right or Left) PANEL, LEFT SIDE VERTICAL 202059-19 Presidential Walnut, Vinyl 202059-20 Painted.
high tech style Item Item Part No. Part No. Description Description 340042-13 Trim, Top Only. Use Only Vinyl Insert 201260-5 Vinyl Insert, Top Trim 340057-2 Trim, Outside Vertical Blk. (Right or Left) 340058-7 Trim, Inside Vertical (Right or Left) PANEL, LEFT SIDE, VERTICAL 202059-31 Sterling Royce, Vinyl PANEL RIGHT SIDE, VERTICAL 202059-25 Sterling Royce, Vinyl...
tron II style Item Item Part No. Part No. Description Description 340055-29 Trim, Horizontal 201417-17 Cover Up Plate, Galvanized 440312-2 Top Insert, Black 660231-24 Trim Horizontal, Top & Bottom, w/Black Stripe 340057-2 Trim, Outside Vertical, Left or Right, Black 340058-8 Trim, Inside Vertical, Left or Right 202059-36 L S V P Dove Gray Tron 340058-1...
mis printout for 110 series snack COMMENTS REPORT DATE 09/23/94 Special notes or Service Mode For Access in BOLD REPORT TIME 09:05 Eight digit machine ID number - Mode Service 0300 ID101 12345678 Number of electronic audits EA301 Number of Audit Resets EA203 Cash Meter, all vends - Mode Service 8 VA101...
trouble shooting chart Problem Cause Remedy No power No lights Check wall outlet for correct wiring, and line cord. See page 3. Lights work - no power Check transformer outputs to board & circuit breakers No power to the board Check wiring connections Defective power board Replace power board...
Page 53
trouble shooting chart Problem Cause Remedy Says make another selection Motor ⁄ cycled Home motor and retry /LCM do mode 5 test vend Selection lost its price Reset prices Motor won't turn Swap shelves with another shelf and retry Check shelf harness connection to board Check 24VAC to logic board (blue wires 110) /white wires...
Page 54
trouble shooting chart Problem Cause Remedy Unable to enter service mode Check plugs on control board Power down and remove and install connectors Defective changer Replace changer Defective main board Replace board Coin mechanism jackpots Incorrect voltage Check voltages± 10% Defective coin mechanism Replace coin mechanism Defective board...
Need help?
Do you have a question about the SNACKSHOP 111 Series and is the answer not in the manual?
Questions and answers