Configuring Wpa-Psk & Wpa2-Psk; Configuring 802.1X; Configuring 802.1X - Peap - TRENDnet TEW-509UB User Manual
54mbps 802.11a/g wireless usb 2.0 adapter with hotspot detector
Hide thumbs
Also See for TEW-509UB:
- User manual (26 pages) ,
- Quick installation manual (17 pages) ,
- Installation manual (8 pages)
Table of Contents
Advertisement
C
WPA-PSK & WPA2-PSK
ONFIGURING
following to configure WPA-PSK & WPA2-PSK.
1.
Click the drop-down arrow at Security Mode and choose WPA-PSK or WPA2-PSK.
2.
Click the drop-down arrow at Encryption Method and choose TKIP or AES. (Most access
points use TKIP for WPA-PSK & WPA2-PSK.)
3.
At PSK Pass Phrase enter the same pass phrase used to configure the WPA-PSK or
WPA2-PSK on your access point.
C
802.1
ONFIGURING
You need to know if your access point supports 802.1x and then apply the configuration here.
1.
Choose the EAP method under Authentication protocol.
2.
Options for User Information depend on the EAP method chosen.
C
802.1
ONFIGURING
Refer to the following to configure PEAP.
(TO BE SUPPORTED)
X
PEAP
X –
26
Refer to the
Advertisement
Table of Contents
