Table of Contents
Advertisement
Chapter 2
Installation
SB-GPIB/TNT for Solaris
7.
Insert the GPIB board into the slot with the GPIB connector sticking
out of the opening on the back panel, as shown in Figure 2-1. Do not
insert the board into a slave-only physical slot if you are using DVMA;
only programmed I/O transfers are possible in slave-only slots. Refer
to the documentation for your Sun SPARC system for information
about DVMA master and DVMA slave slots.
8.
Replace the system unit cover.
9.
Reinstall the GPIB connector extender you removed in Step 5 if you
have problems connecting the GPIB cable to the connector on the
board due to space restraints.
10. Turn on your computer. The GPIB interface board is now installed.
1 Slot 1
2 Slot 2
Figure 2-1. Installing the SB-GPIB/TNT or SB-GPIB
1
3 Back Panel Rail
4 Backplate Adapter
2-2
4
3
2
ni.com
Advertisement
Table of Contents
