Advertisement
Quick Links
Flat-Wall for Curtain Application
©2019 GrowSpan™
All Rights Reserved. Reproduction
is prohibited without permission.
Revision date: 10.23.08
Twist-of-the-Wrist
Assembly Instructions
CLEARSPAN
™
Curved-Wall for Roll-Up Side
STK#
102724
106428
CURTAIN ACCESSORIES
DESCRIPTION
8' Aluminum Rail
16' Aluminum Rail
1
Advertisement
Related Manuals for GrowSpan Twist-of-the-Wrist
Summary of Contents for GrowSpan Twist-of-the-Wrist
- Page 1 CLEARSPAN CURTAIN ACCESSORIES ™ Twist-of-the-Wrist Assembly Instructions Curved-Wall for Roll-Up Side Flat-Wall for Curtain Application STK# DESCRIPTION 102724 8' Aluminum Rail ©2019 GrowSpan™ All Rights Reserved. Reproduction 106428 16' Aluminum Rail is prohibited without permission. Revision date: 10.23.08...
- Page 2 Locknut (1/4"-20) General Information and Overview FAG106B Hex Cap (1/4" x 1-1/2" Zinc) In addition to other uses, the Twist-of-the-Wrist assembly AS2200 Quick Link (1/8" Zinc Plated) allows the operator to "roll up" a window curtain, the side of FA2087 Eyebolt (3/8 x 8 Zinc) a cover (shown above) or the end panel door of a shelter.
- Page 3 Different applications require different installation procedures. It is the customer's responsibility to determine the best way to install a curtain. Operation of Twist-of-the-Wrist assembly (additional purchase required) is the same regardless of the application.
- Page 4 ATTACH CURTAIN (May not apply to all applications.) The instructions below describe how to assemble and Gather the parts: install a single Twist-of-the-Wrist assembly. The procedure • Curtain (additional purchase or customer-supplied) is repeated for additional assemblies (if applicable). A curtain is used in the example.
- Page 5 ™ ATTACH CONDUIT TO CURTAIN OR COVER PANEL The Twist-of-the-Wrist assembly is designed to raise and lower the curtain or a portion of the main cover. These To this point, the top edge of the curtain is secured to the steps describe the Twist-of-the-Wrist assembly and its frame;...
- Page 6 These nuts are used as spacers only. See previous diagram for details. 9. Slide the Twist-of-the-Wrist mounting plate over the long bolts and secure the plate with two locknuts. 5. Secure the bolt to the channel using a 1/4" locknut.
- Page 7 TWIST-OF-THE-WRIST ASSEMBLY (CONTINUED) 18. Use Tek screws and fabric clips (customer-supplied) to secure the curtain to the conduit. Space the fabric clips 12. Slide the square shaft through the Twist-of-the-Wrist evenly along the conduit for best results. May not apply gearbox.
- Page 8 Complete the following steps to install the anti-billow ropes. Building shown may differ from actual building. 1. Using the Twist-of-the-Wrist assembly, roll up the curtain or cover panel a few inches above the ground. NOTE: For the best results, the maximum distance between the screws must not exceed 12'.
- Page 9 CLEARSPAN CURTAIN ACCESSORIES ™ Space below is reserved for customer notes. Revision date: 10.23.08...
Need help?
Do you have a question about the Twist-of-the-Wrist and is the answer not in the manual?
Questions and answers