Advertisement
Quick Links
©2019 GrowSpan
All Rights Reserved. Reproduction
is prohibited without permission.
Revision date: 01.23.19
GROWSPAN
GrowSpan
Round Pro Greenhouses
Photo may show a different but similar model.
ROUND PRO GREENHOUSES AND SYSTEMS
™
BEGIN HERE:
• Frame
• End Panels
™
STK#
DIMENSIONS
104853
20' W x 10' 7" H x 20' L
104854
20' W x 10' 7" H x 24' L
104855
20' W x 10' 7" H x 36' L
104856
20' W x 10' 7" H x 48' L
1
1
Advertisement
Related Manuals for GrowSpan Round Pro
Summary of Contents for GrowSpan Round Pro
- Page 1 GROWSPAN ROUND PRO GREENHOUSES AND SYSTEMS ™ BEGIN HERE: • Frame • End Panels GrowSpan ™ Round Pro Greenhouses Photo may show a different but similar model. STK# DIMENSIONS 104853 20' W x 10' 7" H x 20' L 104854 20' W x 10' 7"...
- Page 2 READ THIS DOCUMENT BEFORE YOU BEGIN • Never erect the structure under power lines. Thank you for purchasing this GrowSpan™ greenhouse. • Identify whether underground cables and pipes are When properly assembled and maintained, this product will present before preparing the site or anchoring the provide years of reliable service.
-
Page 3: Assembly Procedure
GROWSPAN ROUND PRO GREENHOUSES AND SYSTEMS ™ ASSEMBLY PROCEDURE SHELTER CARE AND MAINTENANCE Following instructions as presented will help ensure proper Proper care and maintenance of the shelter is important. assembly of your greenhouse. Failing to follow these steps Check these items periodically to properly maintain shelter: may result in an improperly assembled and anchored •... - Page 4 GROWSPAN ROUND PRO GREENHOUSES AND SYSTEMS ™ REQUIRED TOOLS SPECIAL NOTE: Baseboards for Frame The following list identifies the main tools needed to These instructions describe installing a baseboard assemble the shelter. Additional tools and supports may be (recommended) at ground level along each side of the needed.
- Page 5 GROWSPAN ROUND PRO GREENHOUSES AND SYSTEMS ™ The following graphics and photos will help you identify the different parts and show you how they are used. (Some parts are not shown.) FA4482B CC6212 QH1402 103544 102569 102921B & FA4484B Tek Screw...
- Page 6 GROWSPAN ROUND PRO GREENHOUSES AND SYSTEMS ™ H-CHANNEL INSTALLATION INSTRUCTIONS The new H-channel design requires installation of the flat side facing out with channel side toward the building. Some diagrams and photos in this document show installation of original H-channel with channel side facing out.
- Page 7 GROWSPAN ROUND PRO GREENHOUSES AND SYSTEMS ™ GrowSpan ™ Round Pro Greenhouses and Systems OVERVIEW This section describes assembling your greenhouse. See illustration below to identify main parts of greenhouse. 1. Locate required parts for each assembly procedure. ATTENTION: Position purlins evenly during 2.
- Page 8 GROWSPAN ROUND PRO GREENHOUSES AND SYSTEMS ™ LAY OUT BUILDING SITE 3. Use a transit or line level to drive the second corner post to the same depth as the first ground post. After the site is prepared, lay out building site.
-
Page 9: Rafter Assembly
GROWSPAN ROUND PRO GREENHOUSES AND SYSTEMS ™ ASSEMBLING THE ROUND PRO GREENHOUSE 2. Slide three (3) end purlin clamps over the rafter pipes. FRAME COMPONENTS After the site is prepared and an inventory of parts is complete, continue with the rafter assembly. - Page 10 GROWSPAN ROUND PRO GREENHOUSES AND SYSTEMS ™ RAFTER ASSEMBLY (continued) INTERIOR RAFTER ASSEMBLY Space below is reserved for customer notes. Complete the following steps for the interior rafters. 1. Select the pipes for the first interior rafter assembly and position these on the ground as shown.
-
Page 11: Assemble Frame
GROWSPAN ROUND PRO GREENHOUSES AND SYSTEMS ™ ASSEMBLE FRAME 2. Secure the leg pipes to the ground posts using the 5/16" x 2 1/2" machine bolts and nuts. After all ground posts are driven in place, assemble the frame. Rafter... - Page 12 GROWSPAN ROUND PRO GREENHOUSES AND SYSTEMS ™ FRAME ASSEMBLY (continued) 10. Repeat steps to install the first section of each purlin assembly for first two rafters. 5. As second rafter is steadied, take one 131S075 pipe and insert purlin pipe (plain end) through end clamp of end rafter and through a cross connector of interior rafter.
- Page 13 GROWSPAN ROUND PRO GREENHOUSES AND SYSTEMS ™ FRAME ASSEMBLY (continued) ANCHOR THE ASSEMBLED FRAME 16. Secure each purlin pipe joint with a Tek screw. At this point, anchor the greenhouse frame. Consult the MUST READ document for anchoring information and suggestions.
- Page 14 GROWSPAN ROUND PRO GREENHOUSES AND SYSTEMS ™ STRUT INSTALLATION — FRAME SIDES AT EACH END There are four (4) side struts for the frame. Struts are positioned between end rafters and first interior rafter. Gather parts: • Struts (See Quick Start section for part identification.) •...
- Page 15 GROWSPAN ROUND PRO GREENHOUSES AND SYSTEMS ™ END WALL INSTALLATION • All electrical work to be completed by a licensed electrician and according to established codes. Steps to install end walls for greenhouse include: • For gas heaters, a professional, qualified service 1.
- Page 16 GROWSPAN ROUND PRO GREENHOUSES AND SYSTEMS ™ END WALL INSTALLATION (continued) 9. Measure distance between top of base tube and band clamp (Step 7) to determine length of first frame 4. Secure base tube between end rafter ground posts member of door frame.
- Page 17 GROWSPAN ROUND PRO GREENHOUSES AND SYSTEMS ™ INSTALL THE END WALL FRAME (continued) 17. Using a level (or other means), plumb one door frame tube and tighten band clamp bolt to secure. 15. Using marks on base tube for rough opening for door, attach bottom of each frame member to the base tube 18.
- Page 18 GROWSPAN ROUND PRO GREENHOUSES AND SYSTEMS ™ INSTALL THE END WALL FRAME (continued) 27. Verify vertical frame member is plumb and use short Tek screws to secure square tube fitting to base tube. 22. Using end frame diagrams (Quick Start section), measure and mark (on base tube) locations of remaining vertical frame tubes.
- Page 19 GROWSPAN ROUND PRO GREENHOUSES AND SYSTEMS ™ TAPE SHARP EDGES AND CONNECTORS INSTALL END WALL FRAME (NO DOOR) After entire frame is assembled, check frame for sharp End framing for remaining wall is assembled the same. If edges that could damage cover film. File these smooth or wall includes optional double door kit (additional purchase tape over them using supplied duct tape.
- Page 20 GROWSPAN ROUND PRO GREENHOUSES AND SYSTEMS ™ INSTALL END WALL CLADDING After installing end wall framing, attach polycarbonate panels. Steps that follow describe one way to complete end wall panel installation. Materials and parts needed to install end panels include: •...
- Page 21 GROWSPAN ROUND PRO GREENHOUSES AND SYSTEMS ™ TYPICAL PANEL PREPARATION ATTENTION: Complete the following steps as directed after cutting panels to size. In some instances, this is before panel is attached to frame; in other instances, this is after panel is attached to frame. Procedure depends on panel location.
- Page 22 GROWSPAN ROUND PRO GREENHOUSES AND SYSTEMS ™ Complete these general steps to install end panels. Secure all polycarbonate panels as shown in the diagrams 1. Consult panel location diagrams and begin at the edge and photos below, unless otherwise noted. Evenly space of double door opening.
- Page 23 GROWSPAN ROUND PRO GREENHOUSES AND SYSTEMS ™ END PANEL INSTALLATION (continued) 6. Continue to prepare and install panels and aluminum profile in the locations shown on end panel diagrams 4. Place panel in position, attach it to end wall framing (Quick Start section) to complete lower row of panels.
- Page 24 GROWSPAN ROUND PRO GREENHOUSES AND SYSTEMS ™ END PANEL INSTALLATION (continued) Reserved for Customer Notes 9. Install 104213 u-profile to finish around door opening and along bottom edge of lower panels if this is not completed yet. 10. Apply foil tape (DH8007) to cover open cells of all panels along radius of end rafter.
- Page 25 GROWSPAN ROUND PRO GREENHOUSES AND SYSTEMS ™ Reserved for Customer Notes Revision date: 01.23.19...
- Page 26 GROWSPAN ROUND PRO GREENHOUSES AND SYSTEMS ™ 10'-3 5/16" Height QUICK START GUIDE 20' Round Pro Greenhouse Ground Level 20'-0 5/8" Width FRONT Grid Represents 12" Squares Ground Level Frame shown may differ in length from actual frame. Revision date: 01.23.19...
- Page 27 GROWSPAN ROUND PRO GREENHOUSES AND SYSTEMS ™ Revision date: 01.23.19...
- Page 28 GROWSPAN ROUND PRO GREENHOUSES AND SYSTEMS ™ Revision date: 01.23.19...
- Page 29 GROWSPAN ROUND PRO GREENHOUSES AND SYSTEMS ™ Revision date: 01.23.19...
- Page 30 GROWSPAN ROUND PRO GREENHOUSES AND SYSTEMS ™ Revision date: 01.23.19...
- Page 31 GROWSPAN ROUND PRO GREENHOUSES AND SYSTEMS ™ Revision date: 01.23.19...
- Page 32 GROWSPAN ROUND PRO GREENHOUSES AND SYSTEMS ™ Revision date: 01.23.19...
- Page 33 GROWSPAN ROUND PRO GREENHOUSES AND SYSTEMS ™ Revision date: 01.23.19...
- Page 34 GROWSPAN ROUND PRO GREENHOUSES AND SYSTEMS ™ Revision date: 01.23.19...
- Page 35 GROWSPAN ROUND PRO GREENHOUSES AND SYSTEMS ™ Revision date: 01.23.19...
- Page 36 GROWSPAN ROUND PRO GREENHOUSES AND SYSTEMS ™ Revision date: 01.23.19...
- Page 37 GROWSPAN ROUND PRO GREENHOUSES AND SYSTEMS ™ Revision date: 01.23.19...
- Page 38 GROWSPAN ROUND PRO GREENHOUSES AND SYSTEMS ™ Revision date: 01.23.19...
- Page 39 GROWSPAN ROUND PRO GREENHOUSES AND SYSTEMS ™ Space below is reserved for customer notes. Revision date: 01.23.19...
Need help?
Do you have a question about the Round Pro and is the answer not in the manual?
Questions and answers