Point To Multi Point Configuration - Lindy 38264 User Manual

User Manual

POINT TO MULTI POINT CONFIGURATION

Source
HDMI Cable
USB Cable
Cat.5e/6 Cable
To create a point to multi point installation please be sure to use a dedicated Gigabit Ethernet Switch or a
dedicated VLAN created on a Gigabit switch.
To install a point to multi-point configuration please follow the steps in the previous section taking care to
repeat all steps involving the receiver for each unit installed.
Please Note: When using multiple Receivers and USB input devices in a point to multi-point configuration
press and hold the USB button on any Receiver to gain control of the HDMI source device from that specific
control console.
IMPORTANT! As the extender uses the Broadcast protocol please ensure that you are using a dedicated
network switch or a port based VLAN before connecting the extender, otherwise you may flood the network
causing disruption for other connected devices.
Transmitter Transmitter Transmitter Transmitter Transmitter
(No.38264) (No.38264) (No.38264) (No.38264) (No.38264)
Ethernet Gigabit
Switch
(i.e. No.25047 -
Not Included)
Receiver
(No.38265)
Receiver
(No.38265)
English
Control Console 1
Control Console 2