Step 6 Connecting Other Internal Peripherals - bplan Pegasos II Instruction Manual

Install Internal Peri p herals (lDE Devices)
5
Ste p
-
1. Set the required jumpers of all IDE devices according to the
instructions by the manufacturer. (Harddisk and CDROM/DVD drives
have to be set to Master and Slave modes if you want to connect
more than one IDE device with the same IDE connector on the
mainboard. If there are two Masters or two Slaves on one cable,
they will not function.)
2. Put your IDE devices (harddisks, CDROM/DVD drives, etc.) into the
system case.
Im p ortant: You need to use ATA-1 00 (IDE100) or better cables for
your IDE devices. Old 40 wire cables will not work.
3. Connect an IDE cable on
the back-panel of each IDE
device to the
corresponding headers on
the mainboard. Close the
tabs to secure the
connector. Please note
that IDE cables are
directional and cannot fit
correctly unless proper1y
oriented.
4. Connect an available
power cable to the
backplate of each
peripheral device. Please
note that the power
cable is directional and
will not fit unless
proper1y oriented.
9