Step 1 - Booting From Cd; Step 2 - Configuring A Harddisk - bplan Pegasos II Instruction Manual

SOFlWARE INSTALLATION
133-P19700-002 64M DDR 200M/250E
Welcome to SmartFl.rmware{tm)
SmartF.l rmware (tm) Copyrl.ght 1996-2001 by CodeOen l
All Right::: Re::>erved
Pega!:los BIOS Exten::nons Cop,/rl_ght 2001-2003 by bplan
All Rlght!:l Re::: e rved
ok
When you switch on your Pegasos it will greet you with the Smart Firmware
screen. When the "ok" prompt appears, the system is ready to accept your
commands.
1
Step
Booting from CD
-
1 .
Insert the MorphOSBoot-CD in your CD drive. (If you have more than
one, put it in the first CD drive. If you are unsure which one that is,
simply try putting the CD in each CD drive and try to complete the next
two steps.)
2. List the CD content by typing Is /pcVide/cd and press the ENTER key.
This will show if your CD drive works as expected. (You may press F9 in
order to switch to a smaller font size so you can see more text on the
screen. Pressing F6 will switch back to the bigger font size.)
3. Next, type boot /pcVide/cd boot.img and press the ENTER key.
MorphOS should now successfully boot from CD and load the Ambient
environment.
Step 2 Configuring a Harddisk
-
1 .
Double-click the CD icon in Ambient.
2. Open the ''Tools'' folder with a double-click on it. Execute the program
"SCSlconfig" by double-clicking on its icon.
3.
Select the "ide.device" in the "SCSI Controller" list. There should appear
at least two devices in the "SCSI Drives" list. One of them is your
harddisk, the other one is your CD drive. W
of your hard drive, you will need it later on.
4. Now, select your harddisk and click on the "Partition» button. The
"Partition List" will then pop up. If your hard drive is new, there should
14
for bplan Pegasoo ver::l.lon 0 Ibl07
Ine
(20020919142323)
GmbH
ri
t e down the unit number