bplan Pegasos II Instruction Manual page 16

Name hdO
Start CVI.
End CVI.
Total Cyl.
MBytes
In the "Partition List" window, click on the "OK» button. Back in the
"SCSlconfig" main window, write all changes onto your hard drive by clicking
on the "Save Changes» button. Confirm two times by pressing on "OK» and
leave the program with "Quit». Reboot your system as requested to apply
the changes.
After the reboot, type Is /pcVide/disk@O,O at the SmartFirmware prompt.
With this command you may check if the partitions were installed correctly ..
The first zero in the command stands for Channel 0, the second for Master. If
the unit number you wrote down before is not 0, you have to alter the
command the following way:
Unit 0
•
= =
Unit 1
•
= =
Unit 2
•
= =
Unit 3
•
= =
okls�
RDB patition
0 <FFS>
RDB
patition 1 <SFS>
ok_
If you see an almost identical display as in the figure above, everything
should be alright. If there are DOS partitions instead of RDB partitions, you
will get an ''The Filesystem is not supported" error when booting from hard
drive. (See the Trouble Shooting page for a solution.)
16
II::J
Ho s t ID
Identifier
Mask
Max Transfer
ILJ
Res. low Blocks
EJ
Res. H igh Blocks
Used Blocks
: <bootO> (Ox444F5301)
: <hdO> (0x53465300)
SFS
5121
�
l!2J Mount
Oxfffffffe
Oxffffff
�
m::: :: :J
[ channelO,masterj
[ channelO,slavej
[channel1, master j
[channel1,slavej
Filesvstem
Block Size
Boot
Buffers
Priori tv